Faucet Parts & Accessories (WF003-A19C) Havasu (WF002-A2ORB) Niagara You may need the following tools/materials Valve Hoses (included) Pliers Screw Driver Silicone 2 Wrench Plumbers Tape
Installation Instructions Diagram 1 1.375” (35mm) 2” (50mm) Note: Your faucet is designed for a hole with a diameter of 1 3/8” (35mm) and a deck thickness of up to 2” (50mm). Please shut off water valves before conducting faucet assembly. Diagram 2 Step 1: Attach the O-ring within the circular recess on the bottom of the faucet.
Installation Instructions Diagram 3 HOT COLD Step 2: Connect both water hoses to both cold and hot water ports on the bottom of the faucet. Please note the right hose represents cold water and the left represents hot water. Diagram 4 1 Step 3: Attach the two mounting screws (1) to the faucet by screwing them into the two threaded holes on the bottom of the faucet base.
Installation Instructions Diagram 5 4 5 1 3 2 Step 5: Install the faucet and hoses through the deck mounting hole. Attach the gasket (1), metal base clamp (2) and mounting nuts (3) onto the mounting screws (4). Align the two hoses (5) within the contoured recess of the metal base clamp before tightening the mounting nuts. Diagram 6 1 Step 6: Align the faucet to ensure its appropriately positioned. Next, proceed to tighten the mounting nuts (1) while being mindful not to over-tighten them.
Installation Instructions Diagram 7 Step 7: During faucet installation, filings, chips, and other debris can fall into the plumbing pipes. This debris can damage the internal faucet surfaces which can cause leakage. Before turning on the water valves, make sure the faucet handle is in the open (On) position in order to thoroughly flush out debris. Diagram 8 Step 8: Connect both water hoses onto the respective water valves (we recommend using plumbers tape to prevent leakage). Turn on the water valves.
Installation Instructions Diagram 7 Step 7: After the water valves are turned on, let water filter through the faucet for 30 seconds. Evaluate all connections for leakage. After this process is complete, you may proceed to use your new faucet. Filter Cleaning Instructions for A19 Series Plate Attached Plate Removed 1 2 3 Step 1: To clean the faucet filter screen, unscrew the two Allen wrench screws (1) underneath the faucet. Remove the plate (2).
Manufacturer Limited Warranty All Dyconn Faucet products are manufactured and tested with the highest quality standards and rigorous quality control process. This warranty is limited to the non-commercial use of Dyconn Faucet products purchased and installed in the United States and Canada.