Owners manual

1
XTL
®
300
User Guide
About Your New Label Maker
With the DYMO
®
XTL
™
300 electronic label maker, you can design and print
multiple label types, including barcode labels, panel labels, and heat shrink tubes.
The label maker uses DYMO XTL
™
label cartridges in label widths of 1/4”, 3/8”,
1/2”, 3/4”, or 1” (6 mm, 9 mm, 12 mm, 19 mm, or 24 mm). Labels are available in
a full range of temperature, chemical, and UV-resistant materials, including
continuous tape and pre-sized labels.
Visit www.dymo.com for information on obtaining labels and accessories for your
label maker.
Registering Your Label Maker
Visit www.dymo.com/register to register your label maker online. During the
registration process you will need the serial number, which is located inside the
label compartment cover.
Register your label maker to receive these benefits:
 Notification of software upgrades by email
 Special offers and new product announcements
Getting to Know Your Label Maker
Become familiar with the parts of your label maker as shown in Figure 1.
1 Power/USB connectors 4 LCD display 7 Label compartment
2 On/Off (Cancel printing) 5 Cutter 8 Battery compartment
3 Label exit slot 6 Label compartment
cover release
9 Lanyard loop
2
3
5
9
4
7
8
1
6
Figure 1