Owners manual

2
XTL
®
300
User Guide
Connecting the Power
The label maker is powered by a rechargeable, lithium polymer (LiPo) battery.
The battery installed in your label maker ships partially charged. For best results,
fully charge the battery before using the label maker for the first time.
See Power Status on page 10 for information about visually determining the
battery charging status.
Charging the Battery
Fully charging a discharged battery will take approximately two and a half hours.
You can continue to work as long as the power adapter is connected.
Make sure to read the LiPo battery safety
precautions found on page 51.
To charge the battery
1 On the left side of the label maker,
gently lift and turn the connector cover
to expose the power connector. See
Figure 2.
2 Plug the power cord into the power
adapter. See Figure 3.
3 Plug the barrel end of the power
adapter into the power connector.
4 Plug the power cord into a power outlet.
The power status will show charging in the upper right corner of the
label maker’s display.
Removing and Replacing the Battery
The LiPo battery is designed to provide years of service. In the unlikely situation
that you need to replace the battery, a replacement battery can be ordered from
www.dymo.com.
Make sure the power adapter and USB cable are disconnected before handling
the LiPo battery.
Figure 2
Lift and turn
Figure 3
Power adapter
Power cord
Power connector