Operation Manual

Declaration of Conformity

DYMO Corporation

44 Commerce Road

Stamford, CT 06902-4561

Phone: (203) 355-9000

Fax: (203) 355-9090

Equipment Information

Description: Thermal Transfer Printer

Model: ILP219

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

(Federal Communications Committee) rules. These limits are designed to provide reasonable protection against harmful inter-

ference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-

aged to try correcting the interference by one or more of the following measures:

• Reorient the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

• Use shielded cables to connect this device to computers.

• Consult the dealer or an experienced radio/TV technician for help.

You may find helpful the following booklet, prepared by the FCC: Interference Handbook. This booklet is available from the

U.S. Government Printing Office, Superintendent of Documents, Washington, DC 20402-9325.

WARNING

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment and void the manufacturer’s warranty.

Certification

This device has been tested and complies with the requirements of:

UL 1950

EN60950: Low Voltage Directive Product Safety

FCC Part 15 Class B

EN55022: Radiated and Conducted Emissions B

EN50082-1: Generic Immunity ESD, RF, and Transient Susceptibility

Trademarks

DYMO is a registered trademark of Esselte Corporation. All other trademarks are the property of their respective holders.

Downloaded from www.Manualslib.com manuals search engine