Use and Care Manual

8
ASSEMBLY INSTRUCTIONS
3. Insert one screw (AA) into each of the rear
holes of the cart left side panel and cart right
side panel (E & F), leaving 4-6mm clearance
from screw head to the side panels (E & F).
Attached the cart rear panel (G) by sliding
the keyholes in the cart rear panel over the
inserted screws and then push with force.
Secure the cart rear panel (G) to the bottom
shelf (A) with 2 screws (AA). Tighten the 2
screws on the side panels (E & F).
Hardware Used
AA
M6x12 Screw
x 4
4. Insert 2 screws (AA) into upper front holes
(labeled 1) in cart left side panel and right side
panel (E & F), leaving 4-6mm clearance from
screw head to left and right side panel (E & F).
Attach the upper front door brace (H) with the
larger hole in the upper front door brace (H),
slide the upper front door brace (H) so that
the screw head is over the smaller hole.
Secure the screws but do not tighten
completely. Secure another 2 screws into holes
(labeled 2).
Hardware Used
AA
M6x12 Screw
x 4
3
4
E
G
AA
AA
E
H
E
F
AA
1
2
AA