Use and Care Manual

OPERATION INSTRUCTIONS

Lighting The Grill

Before rst use:

Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important

to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed

and the control knob in the highest position. This will clean the internal parts by burning off any residue

and odor from the manufacturing process.

WARNING

Do not lean over grill when lighting. Read instructions before lighting.

CAUTION

If the ame extinguishes accidentally during ignition or operation, immediately TURN OFF the

cylinder valve and then TURN OFF the control knob.

1. Check that the control knobs are in the O OFF position.

2. Open valve at tank fully by turning counterclockwise.

3. Open lid during lighting.

4. Depress and turn control knob counterclockwise from off position, past the ignite position, to the

high position. You may need to repeat several times to ignite the burner.

If ignition does not occur in 5 seconds, turn the control(s) off, O wait 5 minutes, and repeat the lighting

procedure.

If the burner still does not light, check that there is gas in the cylinder and follow the match lighting

instructions. Check the Troubleshooting Guide on page 26 for more information.