Use and Care Manual

Operation Instructions

NOTE: Other cylinders may be acceptable for use with this appliance provided they are compatible with

the appliance nesting hole and retention means. Refer to Step 16 of the Assembly Instructions for correct

cylinder to cylinder holder connection.

WARNING

ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO

PREVENT FIRE, DAMAGE AND/OR INJURY.

WARNING

In the connection process, make sure:

• the regulator inlet connector mates with the cylinder valve outlet properly, safely and rmly, and;

• the LP gas hose does not come in contact or remain in contact with the rebox.

CONNECTING THE LP TANK

1. The knob on the LP tank must be closed. Make sure that the knob is turned clockwise to a

full stop. The cylinder supply system must be arranged for vapor withdrawal.

2. Check that the control knob on the control unit is turned off.

3. Remove the protective cap from the LP tank valve and coupling nut.

4. Hold the regulator in one hand and insert the nipple into the valve outlet.

Be sure the nipple is centered in the valve outlet. The coupling nut

connects to the large outside threads on the valve outlet.

Use care – do not cross thread the connection.

5. Hand-tighten the coupling nut clockwise until it comes to a full stop.

Firmly tighten by hand only. Do not use tools.

To Disconnect: Fully close the tank valve by turning clockwise.

Tur n the coupling nut counterclockwise until the regulator assembly

detaches.