Installation Guide
16
Shut Down:
1. Turn control knob clockwise to “PILOT” (
). (Normally, burner will make a slight popping sound when
extinguished.) Burner will extinguish but PILOT will remain ON.
2. To extinguish PILOT, depress control knob and continue to turn it clockwise to “OFF” ( O ).
3. Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use.
Note: After use, some discoloration of the emitter screen is normal.
Re-Lighting:
Note: For your safety, control knob cannot be turned “OFF” ( O ) without rst depressing the control knob in
“PILOT” (
) position and then rotating it to “OFF” ( O ).
1. Turn control knob to “OFF” ( O ).
2. Wait at least 5 minutes to let gas dissipate before attempting to relight Pilot.
3. Repeat the “Lighting” steps on prior page.
Operation Checklist
For a safe and pleasurable heating experience, perform this check before each use.
Before Operating:
1. I am familiar with entire owner’s manual and understand all precautions noted.
2. All components are properly assembled, intact and operable.
3. No alterations have been made.
4. All gas connections are secure and do not leak.
5. Wind velocity is below 10 mph / 8.046km/h.
6. Unit will operate at reduced efciency below 40°F / 4°C.
7. Heater is outdoors (outside any enclosure).
8. There is adequate fresh air ventilation.
9. There is an AAA battery inside the Electric igniter and the battery is new.
OPERATION INSTRUCTIONS
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually
ignite this heater. Holding in the control knob
for more than 10 seconds before igniting the
gas will cause a ball of ame upon ignition.
WARNING
FOR YOUR SAFETY
Heater will be hot after use. Handle with
extreme care.