Installation Guide

8
6
6. Unscrew ignitor knob (marked with lighting bolt) from the
control panel on the head assembly (C). Insert AAA battery
(MM) with positive end (+) outward. Replace ignitor knob.
5. Load Cylinder Housing (D) onto Post (E).
Slide Cylinder housing (D) down.
ASSEMBLY INSTRUCTIONS
5
6
C
MM
Hardware Used
MM
x 1AAA Battery
The electronic ignition requires 1 “AAA” alkaline battery, which is included.
WARNING
DO NOT mix old and new batteries.
DO NOT mix alkaline, standard (Carbon-Zinc), or rechargable (Nickel-Cadmium) batteries.
DO NOT dispose of batteries in re. Improper disposal may cause batteries to leak or explode.
NOTE: If you purchased a separate
table accessory, please refer to that
manual now. If you do not refer to that
manual at this time you will have to
disassemble the unit in order to add
the table accessory.
E
D