Use and Care Manual

OPERATION INSTRUCTIONS

Leak Check

WARNING

• Perform all leak tests outdoors.

• Extinguish all open ames.

• NEVER leak test when smoking.

• Do not use the heater until all connections have been leak test and do not leak.

1. Make 2-3 oz. of leak check solution (one part liquid dishwashing detergent and three parts water).

2. Put leak solution in a spray bottle.

3. Make sure control valve and cylinder valve are OFF.

4. Apply several drops of solution where hose attaches to regulator.

5. Apply several drops of solution where regulator connects to cylinder.

6. Apply several drops of solution where hose connects to gas control valve.

7. Turn cylinder valve ON.

If bubbles appear at any connection, there is a leak.

1. Turn cylinder valve OFF.

2. If leak is at hose/regulator connection, the regulator and hose assembly (RR) should be returned

to the place of purchase.

3. If leak is at regulator/cylinder valve connection: disconnect, reconnect, and perform another

leakcheck. If you continue to see bubbles after several attempts, cylinder valve is defective and

should be returned to cylinder’s place of purchase.

4. If leak is at hose/gas control valve connection: tighten connection and perform another leak test.

If bubbles continue appearing, the regulator and hose assembly (RR) and head assembly (C)

should be returned to the place of purchase.

If NO bubbles appear at any connection, the connections are secure.

NOTE: Whenever gas connections are loosened or removed, you must perform a complete leak test.

Regulator/Cylinder

connection

Hose/Regulator

connection

hose/gascontrol

valve connection

DANGER

• CARBON MONOXIDE HAZARD!

• For outdoor use only. Never use inside building, garage, or other unventilated or enclosed

areas. This heater consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid

endangering your life.