Use and Care Manual

4
ASSEMBLY INSTRUCTIONS
3. Unscrew the four stainless steel M6x10mm bolts
 connectingthepostandthereector/head
assembly and put them aside for later use.
 Removethecompletereectorandhead
assembly from the post. Be careful that the
regulator does not hook onto the post when
 takenout.Putthereectorandheadassembly
aside.
3
Note: If this is a new unit, please see the
instruction manual included with the patio
heater to begin assembly.
If you are placing this on an already
assembled unit:
2. a. Make sure the control knob is in the OFF
position and the patio heater has cooled.
b. Lift up the cylinder housing.
c. Close the cylinder valve by turning clockwise.
Disassemble the regulator and the cylinder
valve.
d. Remove the propane cylinder from the base.
2
Control Knob
Reector&
Head Assembly
Stainless Steel
M6x10mm Bolts
Post
Cylinder Housing
Base
Cylinder Valve
Regulator and
Hose Assembly