Use and Care Manual

Step 4

ASSEMBLY INSTRUCTIONS

4. Remove the cylinder housing and put it aside.

Laythebaseassemblydownontheoor.Attach

thethreenailxingbrackets(E)tothebasewith

six M6X10 mm bolts (AA) and six washer Ø6 (CC)

as illustrated. Secure with six M6 nuts (BB). Tighten

with the wrench (DD).

Note: If this is your rst time assembling the unit

with the table, begin the table assembly here.

If you disassembled a previously owned unit,

continue to add the table:

5. Slide the fastener (D) and table assembly

onto the post as illustrated. Do not tighten the

fastener (D) at this time.