Product Manual

6
WoodCeiling WoodCeiling
MOUNTING THE BRACKET
RefertoFigures4aand4b.
1.Locateawoodstudinthewoodceilingjoist.Ifyoucannotlocateawood
  stud,youhavetoinstallawoodpieceontheceilingasthisheatermustbe
  securelyfastened.
2.Removethemountingbracketfromtheheatingunitbylooseningbracket
  screwswithawrenchandslippingthehandleoffoverthescrewheads.
3.Placeawasheronscrewsbeforeinsertingthroughtheholesinthemounting
  bracketandscrewthemsecurelyintoaceilingjoist.
NOTE:Ifyouwanttoswiveltheheatereithertotherightorleftaddingawasher
tobothsidesofthebracketisrecommended.Alongerlagboltmayberequired
toproperlysecuretheunit.SeeFigure4a.
HANGING THE HEATER
1. Attachtheheatingunittothemountingbracket.
2. Lifttheheaterupandintothemounting
  bracket.
3. Alignthebracketscrewswiththekeyholeslots
  inthemountingbracket.
4. Iftheheateristobetilteditmustbepositioned
  inthekeyholeslots-seegure5.
5. Tightenthebracketscrewswithawrenchso
  theunitissecurelysuspendedathorizontalor
  verticallevel.
Figure 5
ADJUSTING AIR FLOW DIRECTION
1.Toturntheunitwhenithasbeeninstalled
withasinglelagbolt(asshowningure
4a),simplyturntheentireheaterasneeded.
Theunitcannotbeturnedhorizontallyifit
hasbeeninstalledwith2lagbolts.
2.Totilttheunitvertically,loosenthebracket
screws(seegure5).
Figure 4a. Single-Screw Mounting Figure 4b. Double-Screw Mounting
INSTALLATION