Use and Care Manual
12
OPERATING INSTRUCTIONS
Check that the garage heaters outlet grill is not covered or obstructed in anyway, and make
sure the power to the unit is switched on.
The garage heater control functions can be accessed in three (3) ways:
• Using the touchpad control panel, located on the front of the garage heater below the air
guide plates.
• Using the multifunction remote control unit.
• Using the application on your mobile device
Icon What the heater will do:
Figure 1
Main Power Button:
This button supplies power to all of the garage heaters functions. It must
be turned on for the garage heater to work
Figure 2
Heater Control Button:
This button adjusts the 4 heating stages: AU, H, L, FA: AU (The heater
will adjust between Low (5000W displays “L”) and High (7500W displays
“H”) based on room temperature) ; H (high 7500W displays “H”); L (Low
5000W displays “L”) ; FA (Fan Only).
Figure 3
Temperature/Timer Display:
This LED display shows the set point for the temperature and timer
functions. When either of these functions is activated, the display reects
the set point for ve seconds and then fades to black. Any change to he
set point of the temperature or timer will reactivate the display, which
again fades after ve seconds.
Figure 4
DOWN Control Button:
This button is used to decrease temperature or timer settiing. It adjusts
the temperature range between 10°C - 35°C (50°F - 95°F) in 1°F (/1°C)
increments.
Figure 5
UP Control Button:
This button is increasing temperature or timer setting. It adjusts the
temperature range between 10°C - 35°C (50°F - 95°F) in 1°F (/1°C)
increments.
Figure 6
Timer Button:
This button controls the Timer ON/OFF and 8 settings from 1hour to 8
hours. When the Timer is rst turned on, it will come on at the shortest
time setting (1hour). Each time the Timer button is pressed, the time
increases by 1 hour, up to the longest setting (8 hours). Once the set
time expires, all garage heaters functions will be automatically turn off.