Use and Care Manual
4
ITEM PAGE #
SPECIFICATIONS ........................................................................... 4
SAFETY INFORMATION ................................................................. 4
LOCATING HEATER ....................................................................... 5
PRE-INSTALLATION ....................................................................... 6
INSTALLATION ............................................................................... 7
OPERATING INSTRUCTIONS ........................................................ 11
MAINTENANCE .............................................................................. 15
REPLACEMENT PARTS ................................................................. 15
TROUBLESHOOTING .................................................................... 16
1. Use only copper wires rated for at least 60ºC.
2. Heater air ow must be directed parallel to or away from adjacent wall.
3. Observe all wall, oor and ceiling clearance requirements.
4. All wiring must be done according to national and local electrical codes. The
heater must be grounded as a precaution against possible electrical shock.
Heater circuit must be protected with proper fuses.
5. The mounting structure and the anchoring hardware must be capable of
supporting the weight of the heater and the mounting bracket (if used).
Rating Heat Setting Volts Phase Hertz Amps BTU/hour
7500 High 240 1 60 31.3 25590
5000 Low 240 1 60 20.8 17060
5600 High 208 1 60 26.9 19107
3700 Low 208 1 60 17.9 12625
TABLE OF CONTENTS
SPECIFICATIONS
SAFETY INFORMATION
THIS HEATER REQUIRES HARDWIRE INSTALLATION (NO PLUG). THE INSTALLATION OF THIS
PRODUCT MUST BE CARRIED OUT BY A CERTIFIED ELECTRICIAN AND IN ACCORDANCE WITH
ALL LOCAL AND NATIONAL ELECTRICAL CODES.
NOTE: COMPATIBLE WITH A 240V LINE VOLTAGE DOUBLE POLE WALL THERMOSTAT. MUST BE
INSTALLED BY A CERTIFIED ELECTRICIAN.
READ AND UNDERSTAND ALL INSTALLATION & OPERATION INSTRUCTIONS PRIOR TO
OPERATING THIS UNIT. OBSERVE ALL SAFETY INSTRUCTIONS.
WARNING