Operating instructions
3
E
N
G
L
I
S
H
General Safety Information
(Continued)
10. Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause a fire or injury to persons.
11. Provide adequate ventilation. Before
using heater, provide at least a 3.0
square foot opening of fresh, outside
air for every 100,000 BTU/Hr rating.
12. Do not modify or alter this heater in
any way or operate any heater that has
been modified from its original state.
13. It is hard to anticipate every use
which may be made of the heater.
Check with your local fire safety
authority if you have any questions
about heater application.
14. Be sure heater is on a solid and level
surface.
Propane Gas: Propane gas is odorless.
An odor-making agent is added to
propane gas. The odor helps you detect
a propane gas leak. However, this odor
may fade in time. Propane gas may be
present in the area even though no odor
is detected.
15. Use only propane gas. Do not
attempt to use natural gas.
16. Keep appliance clear and free from
combustible materials, gasoline,
paint thinner, and other flammable
vapors and liquids. Dust is com-
bustible. Do not use heaters in areas
with high dust content.
17. Check heater for damage before each
use. Do not use damaged heater.
Minimum heater clearance from
combustibles:
Sides: 6 feet Top: 5 feet
Floor: Combustible - Not for use
on finished floors
18. The heater, other than a heater
with an integral propane gas
cylinder, must be located at
least (i) 6 ft. (1.83 m) in the U.S.;
or (ii) 10 ft. (3 m) in Canada,
from any propane gas cylinder.
19. The propane cylinder supply system
must be arranged to provide
for vapor withdrawal from the
operating cylinder.
20. Blower or radiant type heaters shall
not be directed toward any propane
gas cylinder within 20 feet (6 m).
21. Check hose before each use of
heater. Do not use if hose is cut
or damaged. Replace with hose
specified by manufacturer.
22. The heater is not intended for use
on finished floors. Warping or other
damage may occur.
23. Place heater away from any breezes
or drafts. Keep away from dripping
water or rain.
24. Keep small children and animals
away from the heater.
25. Always wear gloves when handling
the heater to prevent injury.
26. Never attach ductwork to heater.
27. Use only original replacement parts.
This heater must use design specific
parts. Do not substitute or use generic
parts. Improper replacement parts
could cause serious or fatal injury.
Assembly
1. Provide propane gas supply only.
2. Connect heater to a proper gas supply
using the supplied regulator, and turn
knob on LP cylinder on.
3. Wait 5 minutes for any gas to clear.
Smell for gas; if you do not smell gas,
heater is ready to operate.
Never use an open
flame to check for a
leak. Apply 50/50 mixture of liquid soap and
water to all joints. Bubbles forming show a
leak. Correct all leaks at once.
Operation
This heater should only be used with
a tank that has a vapor withdrawal
system. Refer to the Standard of
Storage and Handling of Liquefied
Petroleum Gas, ANSI/NFPA 58, Chapter
5. Your local fire department or library
will have this information.
TO START HEATER
1. Follow all of the safety, ventilation
and installation instructions
previously noted in this manual.
2. Always be sure to place the heater on
a stable and level surface while the
heater is in operation. Be sure that no
strong winds blow into the ends of the
heater.
3. Turn control knob clockwise to “OFF”
position.
4. Turn LP gas supply valve on.
5. Depress heater control knob and turn
COUNTERCLOCKWISE
to “(IGN)
LOW” position to light burner.
Model RA125LPDGD
Dyna-Glo Delux Operating Instructions and Parts Manual
Figure 2 – Control Knob
PROFESSIONAL GRADE
For Technical Support or Troubleshooting, Call: 1-877-447-4768, 8:30 am - 4:30 pm CST www.ghpgroupinc.com