User's Manual

ManualsBrandsDyna-Glo ManualsElectric HeaterDyna-Glo RMC-KFA170TDLX

4 2 21- 0 0 5 9- 0 0

06/04 Rev. 00EDITION 2004

PORTABLE

FORCED AIR HEATERS

“USER’S MANUAL”

Before the first use of this heater, please read this USER’S MANUAL very

carefully. This USER’S MANUAL has been designed to instruct you as to

the proper manner in which to assemble, maintain, store, and most

importantly, how to operate the heater in a safe and efficient manner.

Please keep this manual for future reference.

CFM HOME PRODUCTS

2695 MEADOWVALE BOULEVARD

MISSISSAUGA, ONTARIO L5N 8A3

1-800-668-5323

MODEL : RMC-KFA65TDLX, RMC-KFA120TDLX

RMC-KFA170TDLX

LISTED

Summary of content (12 pages)

PAGE 1
PORTABLE FORCED AIR HEATERS “USER’S MANUAL” LISTED MODEL : RMC-KFA65TDLX, RMC-KFA120TDLX RMC-KFA170TDLX Before the first use of this heater, please read this USER’S MANUAL very carefully. This USER’S MANUAL has been designed to instruct you as to the proper manner in which to assemble, maintain, store, and most importantly, how to operate the heater in a safe and efficient manner. Please keep this manual for future reference.
PAGE 2
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! CONTENTS OF USER’S MANUAL DANGER IMPROPER USE OF THIS HEATER CAN RESULT IN SERIOUS INJURY OR DEATH FROM BURNS, FIRE, EXPLOSION, ELECTRICAL SHOCK AND/OR CARBON MONOXIDE POISONING. ITEM WARNINGS: 1. RISK OF INDOOR AIR POLLUTION! • Use this heater only in well ventilated areas. Provide at least a three-square foot (2,800 sq. cm.) opening of fresh outside air for each 100,000 BTU/hr. of heater rating.
PAGE 3
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 3. UNPACKING AND ASSEMBLY 1. REMOVE THE HEATER AND ALL PACKING MATERIALS FROM THE BOX. NOTE : Save the shipping carton and packing materials for future storage. Wheel Wheel Bar Wheel Cap Front Handle Handle Cord Wrap Screws Screws(A) and Screws(B) Bushing Cotter Pin and Washer Figure 2.
PAGE 4
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 2. ASSEMBLY A. For RMC-KFA65TDLX Model only (See Figure 6,7) Tools Required • Medium Phillips Screwdriver 1. Assembling Handle. 1) Align boss on bottom of handle with the 2 holes on the shell cover as shown in Figure 6 NOTE : Be sure to match the tab in the bottom of the handle with the slot in housing cover. 2) Insert screws into the holes in the handle and tighten each screw. Figure 6. Handle Assembly 2.
PAGE 5
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 5. OVERVIEW OF HEATERS DESIGN 7. OPERATION A.) VENTILATION Fuel System : This heater is equipped with an electric air pump that forces air through the air line connected to the fuel intake and then through a nozzle in the burner head. When the air passes in front of the fuel intake it causes fuel to rise from the tank and into the burner nozzle.
PAGE 6
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 8. LONG TERM STORAGE OF YOUR HEATER FUEL TANK DRAIN 1. Remove Fuel Cap and Cap Fuel Filter(See Figure 10). 2. Drain Fuel Tank through Fuel Cap Opening and wash Fuel Cap Filter with clean fuel. 3.Using a small amount of kerosene,swirl and rinse the inside of the tank. Never mix water with the kerosene as it will cause poor operation of the heater. Pour the kerosene out making sure that you remove it all.
PAGE 7
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! D.) FAN BLADES F.) SPARK PLUG CLEAN EVERY SEASON OR AS NEEDED. -Remove upper shell(See 10 page.) -Use 1/8" allen wrench to loosen set screw which holds Fan Blade to motor shaft. CLEAN AND REGAP EVERY 600 HOURS OF OPERATION OR REPLACE AS NEEDED. -Remove upper shell(See 10 page). - Slip Fan Blade off motor shaft. -Remove Fan Blade(See 11 Page).
PAGE 8
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! H.) FUEL FILTER 10. TROUBLE SHOOTING GUIDE CLEAN OR REPLACE TWICE A HEATING SEASON OR AS NEED. -Remove upper shell(See 10 page). -Remove Fan Blade(See 11 Page). -Pull Fuel Line off from Fuel Filter Neck. -Remove Fuel Filter. -Wash Fuel Filter with clean kerosene and replace in tank. -Attach Fuel Line to Fuel Filter Neck. -Replace Fan Blade and Upper Shell. Figure 18. Removing Fuel Filter I.
PAGE 9
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 11. WIRING DIAGRAM 12. SPECIFICATIONS A) WIRING DIAGRAM(RMC-KFA65TDLX) RMC-KFA65TDLX KFA120T-DLX KFA170T-DLX B) WIRING DIAGRAM(RMC-KFA120TDLX/RMC-KFA170TDLX) H 25" 25" D 32.1" 36.9" W 18.5" 18.5" RMC-KFA120TDLX / RMC-KFA170TDLX MODEL RMC-KFA65TDLX BTU/Hr. 65,000 120,000 170,000 Fuel Consumption - Gal./Hr. 0.5 0.9 1.3 Fuel Tank Capacity - Gal. 5.0 10.0 12.0 Pump Pressure PSI 3.
PAGE 10
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 13. EXPLODED PARTS DRAWING 14. PARTS LIST(RMC-KFA65TDLX Model Only) KEY NO.
PAGE 11
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 15. EXPLODED PARTS DRAWING(RMC-KFA120T/170TDLX Models Only) 16. PARTS LIST(RMC-KFA120T/170TDLX Models Only) KEY NO.
PAGE 12
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 17. PARTS LIST (WHEELS AND HANDLE) KEY NO. 23-8 23-9 23-10 23-11 23-12 23-13 23-14 23-15 23-16 23-17 23-18 23-19 23-20 24 25 26 27 28 29 30 31 32 33 33-1 33-2 34 35 36 37 38 DESCRIPTION Rotor Kit Blade End Pump Cover Nipple(Air) Flange Bolt Lint Filter Output Filter Filter Kit End Filter Cover Ball Spring Plug/Pump Adj.