Installation Guide

ManualsBrandsDyna-Glo ManualsGas Heaters40,000 BTU 360-Degree Tank Top Gas Portable Heater

Questions, problems, missing parts? Before returning to your retailer, call our customer

service department at 877-447-4768 8:30 a.m. – 4:30 pm CST, Monday – Friday

or email us at customerservice@ghpgroupinc.com

www.ghpgroupinc.com

USER’S MANUAL AND OPERATING INSTRUCTIONS

PROPANE TANK TOP

CONSTRUCTION HEATER

GENERAL HAZARD WARNING

FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH

THIS HEATER, CAN RESULT IN DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS,

OR DAMAGE FROM THE HAZARDS OF FIRE, EXPLOSION, BURN. ASPHYXIATION, CARBON

MONOXIDE POISONING, AND/OR ELECTRICAL SHOCK.

ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW THE INSTRUCTIONS SHOULD

USE OR SERVICE THIS HEATER.

IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS AN INSTRUCTION

MANUAL, LABELS, ETCETERA, CONTACT THE MANUFACTURER.

CONSUMER: Retain this manual for future reference.

Printed in China IMTT360DG - KCG

MODELS: TT360L TT360PL TT360H

TT360PH TT360DG TT360PDG

TT360DGP TT360PDGP TT360DGD

TT360PDGD TT3-40C TT40000M

C US

GHP Group, Inc.

6440 W Howard St

Niles, IL 60714-3302

ANS Z83.7-2011 CSA 2.14-2011

Adequate ventilation must be provided.

Summary of content (20 pages)

PAGE 1
PROPANE TANK TOP CONSTRUCTION HEATER USER’S MANUAL AND OPERATING INSTRUCTIONS MODELS: TT360L TT360PL TT360H TT360PH TT360DG TT360PDG TT360DGP TT360PDGP TT360DGD TT360PDGD TT3-40C TT40000M C US ANS Z83.7-2011 CSA 2.14-2011 Adequate ventilation must be provided. GHP Group, Inc.
PAGE 2
PAGE 3
TABLE OF CONTENTS General Safety Information .............................................................................. 3 - 4 Specifications .............................................................................................................. 3 Product Features ..................................................................................................... 4 Heater Assembly .......................................................................................................
PAGE 4
PROPANE TANK TOP HEATER PROPANE TANK TOP CONSTRUCTION HEATERS The heater is designed and approved for use as a construction heater under ANSI Z83.7, CSA 2.14. It is hard to anticipate every use which may be made of this heater. CHECK WITH YOUR LOCAL FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS. Other standards govern the use of fuel gases and heat producing products in specific applications. Your local authority can advise you about these.
PAGE 5
PROPANE TANK TOP HEATER GENERAL SAFETY INSTRUCTIONS Accidents are always tragic especially because so many of them could have been prevented with a little care and judgment. There are some basic good practices, we hope you will follow for safe use of your heater. IMPORTANT SAFETY INFORMATION • Children should be carefully supervised, when they are in the area. • Always maintain proper clearance from combustible materials. Minimum clearance from combustibles.
PAGE 6
PROPANE TANK TOP HEATER TT360 SERIES HEATER ASSEMBLY Tools Required: Phillips head screwdriver Estimated Assembly Time: 5 minutes Contents: Tank Top Heater (1) Tank Collar Bracket (1) M4x8 Machine Screws (2) DUAL BURNER MODEL The tank collar bracket must be assembled before the heaters can be attached to the propane tank. 1. Align bolt holes in tank collar bracket with bolt holes in mounting plate on heater. 2.
PAGE 7
PROPANE TANK TOP HEATER WIRING DIAGRAM ELECTRODE earth yellow TIP OVER SWITCH PIEZO IGNITER *Piezo models only THERMOCOUPLE black yellow NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! M,P,U SAFETY VALVE 6
PAGE 8
PROPANE TANK TOP HEATER PROPANE SUPPLY This heater requires a 20 lb propane cylinder for operation. (Not included). The propane (LP) gas tank must also be equipped with the following: • A collar to protect the propane gas valve. • A shutoff valve terminating a Propane gas cylinder valve outlet as specified in the American National Standard for Compressed Gas Cylinder Valve Outlet and Inlet Connections. • A safety relief valve having direct communications with the vapor space of the tank.
PAGE 9
PROPANE TANK TOP HEATER CONNECTING HEATER TO PROPANE TANK Read and understand all safety information before connecting heater to propane tank. 1. Place heater onto tank with tank collar bracket over tank collar (Fig. 2). Mounting bolt knob should be positioned to the outside of tank collar and be positioned as closely as possible directly opposite to the cylinder valve outlet. See Figures 1 and 2. 2. Firmly secure to tank by hand-tightening mountingbolt knob. Do not overtighten mounting bolt knob. 3.
PAGE 10
PROPANE TANK TOP HEATER CONNECTING HEATER TO PROPANE TANK FIGURE 2 9 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
PAGE 11
PROPANE TANK TOP HEATER CHECKING FOR LEAKS Check all gas connections with a 50/50 soap and water solution to be sure they are tight and leak proof. The formation of bubbles indicate a gas leak. Correct all leaks before using the heater. • The installation of your heater must meet all local codes and/or gas utility requirements or, in the absence of local codes, with the Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58 and the Natural and Propane Installation Code, CSA B149.1.
PAGE 12
PROPANE TANK TOP HEATER LIGHTING INSTRUCTIONS WHEN USING MATCH (CONTINUED) FIGURE 3 1. STOP! Read all safety information first. 2. Turn heater regulator knob counterclockwise to (OFF) [ ] position. 3. Slowly Open Cylinder valve by turning counterclockwise . 4. Wait five(5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow the safety information on the tag attached to the heater. If you do not smell any gas, go to the next step. 5.
PAGE 13
PROPANE TANK TOP HEATER TURNING OFF THE HEATER 1. Tightly close propane tank valve by turning fully clockwise 2. Turn the heater regulator knob to the (OFF) [ before handling heater. . ] position. Wait at least 30 minutes for the heater to cool 3. Always remove the heater from the propane tank after each use and store indoors. Do not store heater while attached to propane tank. Do not store propane cylinders in a building, garage or any other enclosed area.
PAGE 14
PROPANE TANK TOP HEATER LIGHTING INSTRUCTIONS FOR PIEZO IGNITION MODELS (CONTINUED) 1. Stop! Read all safety information first. 2. Turn heater regulator knob counterclockwise to (OFF) [ ] position. WARNING: Stand to the side of unit while lighting. Do not stand or have any part of your body over or near the heater while lighting. 3. Slowly open cylinder valve by turning counterclockwise . 4. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
PAGE 15
PROPANE TANK TOP HEATER LIGHTING IN WINDY AREAS When using this heater indoors where there is wind, it will be necessary to use a match or long stem butane lighter to ignite the burner. It may be difficult to keep the match lit long enough under windy conditions. Follow the “Lighting instructions when Using a Match” procedure after doing the following: 1. Position the heater and cylinder such that the Thermocouple is opposite the direction that the wind is coming from. 2.
PAGE 16
PROPANE TANK TOP HEATER TROUBLESHOOTING PROBLEM 1. Unit will not light. 2. Burner will not stay lit when gas valve plunger released. 3. Excessive flames coming out of burner, not glowing red. POSSIBLE CAUSE CORRECTIVE ACTION 1. Valve on propane cylinder not open. 2. Propane cylinder empty 2. Have cylinder refilled. 3. Regulator not in "Low" position 3. Turn regulator to "Low" position. 4. Excess flow device triggered. 4. Close cylider valve, wait 5 minutes and reopen slowly. 5.
PAGE 17
PROPANE TANK TOP HEATER REPLACEMENT PARTS ILLUSTRATION NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 16
PAGE 18
THIS PAGE INTENTIONALLY LEFT BLANK.
PAGE 19
WARRANTY LIMITED WARRANTY: This limited warranty is extended to the original retail purchaser of this Forced Air/Convection/Radiant Heater and warrants against any defect in materials and workmanship for a period of one (1) year from the date of retail sale. GHP Group, Inc., at it’s option, will either provide replacement parts or replace or repair the unit, when properly returned to the retailer where purchased or one of our service centers as directed by GHP Group, Inc.
PAGE 20
WARRANTY REGISTRATION IMPORTANT: We urge you to fill out your warranty registration card within fourteen (14) days of date of purchase. You can also register your warranty on the internet at www.ghpgroupinc.com. Complete the entire serial number. Retain this portion of the card for your records. GHP Group, Inc. GHP Group, Inc. St 6440 W Howard 8280 Austin Ave. Niles, IL 60714-3302 Morton Grove, IL 60053-3207 GHP Tel: (877) 447-4768 Tel:www.ghpgroupinc.com (877) 447-4768 www.ghpgroupinc.