Owner`s manual

ASSEMBLY

Non-Threaded

Make sure the axle nuts are tight with a 15mm

wrench or adjustable wrench. Place the domed

washer (if supplied) over the axle and axle nut. Slide

the peg onto the axle, and then using the supplied

tool or a 15mm socket and extended driver, thread

the peg-fixing nut onto the axle. Tighten the nut

clockwise until snug. Repeat for all the remaining

pegs.

Threaded

This style of peg is threaded to fit the axle. Make sure

axle nuts are tight using a 15mm wrench or adjustable

wrench. Place the domed washer (if supplied) over the

axle and axle nut, and then thread the peg on the axle

turning clockwise until snug.

PLEASE NOTE: Not all axles are able to accept axle pegs. Please consult your local

bicycle specialist if you have any questions. Some BMX bicycles come with two or four pegs.