User manual

Finally switch back to “OFF”.
Suggestion: If in the future you wish to transfer your cruise control to the next car, it is a good idea not
to use accessory 10 or 11 but instead use the inside of a connector block (electrical) so it is only a
question of unscrewing. Never shorten the accelerator cable.
Instructions to set
Step 1. Accelerate to desired speed with switch in “Off” position.
Step 2. On reaching your desired speed, switch to “ON”.
Step 3.
Turn switch clockwise until it stops and you can release the accelerator.
Note: if the switch will not go easily to”ON” then also turn it clockwise during switching.
To increase the speed for a short period when driving on the cruise control.
Step 1. Depress the accelerator.
Step 2. When you release the accelerator your car returns to the preset speed.
To stabilise your increased speed when driving on the cruise control.
Step 1. Depress the accelerator until you reach the new desired speed.
Step 2. Turn the switch clockwise until it stops.
Note: This method can also be used when climbing up slopes.
To stabilise your decreased speed when driving on the cruise control.
Step 1. Turn the switch anti-clockwise.
Note: This method can also be used when descending a long slope.
To disengage the cruise control:
Step 1. Automatically - by braking.
Step 2. Manually - by depressing the red re-set button.
Note: The brake warning light now does not light up.
Warning!! When your brake light switch is defective, applying the brakes will not automatically
disengage the cruise control.
Note: For vehicles that have a powerful return spring on the throttle (such as diesels) it is desirable to
try and achieve 60mm of travel on the point of attachment to the throttle cable so as to reduce the
force on the internal gears of this device.
.
