User manual

5 of 30
1. Welcome
The DynaGen Configurator PC software interface is a program that allows the
programming and customization of the DynaGen GSC300 AutoStart Engine Controller.
The GSC300 can be programmed manually via front panel buttons OR with our easy-to-
use PC software interface that allows customization of messaging; languages; sender
selections; control settings; and much more. Although the GSC300 may be easily
configured for common parameters from the front panel buttons, the Configurator PC
software interface allows full and more advanced programming capabilities. The PC
interface can be programmed through a parallel port or through a USB adaptor.
** CHANGE TO SOFTWARE ISSUED LATER THAN JUNE 15/08**
The programming of a GSC300 can now be done with either a parallel port
(Windows XP and earlier) or USB (Windows XP and latter) programmer. If using
USB, you will need to use the Read and Store buttons under the USB heading. If
using a parallel port you will need to use the Load and Store buttons under the
Parallel port heading.
When changing messages you will need to click the check mark for USB in the
Change Message window before reading or storing messages.
DO NOT connect the programmer into the GSC300 when it is powered. This may
corrupt the GSC300.