User`s manual

For Installation
 Use only the type of power source indicated on the marking
labels.
 Use only power adapter supplied with the product.
 Do not overload wall outlet or extension cords as this may
increase the risk of electric shock or fire. If the power cord is frayed, replace it with
a new one.
 Proper ventilation is necessary to prevent the product
overheating. Do not block or cover the slots and openings on the device, which are
intended for ventilation and proper operation. It is recommended to mount the
product with a stack.
 Do not place the product near any source of heat or expose it
to direct sunlight.
 Do not expose the product to moisture. Never spill any liquid
on the product.
 Do not attempt to connect with any computer accessory or
electronic product without instructions from qualified service personnel. This may
result in risk of electronic shock or fire.
 Do not place this product on unstable stand or table.
For Using
 Power off and unplug this product from the wall outlet when it
is not in use or before cleaning. Pay attention to the temperature of the power
adapter. The temperature might be high.
 After powering off the product, power on the product at least
15 seconds later.
 Do not block the ventilating openings of this product.
 When the product is expected to be not in use for a period of
time, unplug the power cord of the product to prevent it from the damage of storm
or sudden increases in rating.
For Service
Do not attempt to disassemble or open covers of this unit by yourself. Nor should you
attempt to service the product yourself, which may void the user’s authority to operate it.
Contact qualified service personnel under the following conditions:
 If the power cord or plug is damaged or frayed.
 If liquid has been spilled into the product.
 If the product has been exposed to rain or water.
 If the product does not operate normally when the operating
instructions are followed.
 If the product has been dropped or the cabinet has been
damaged.
 If the product exhibits a distinct change in performance.
Warning
 This equipment must be installed and operated in accordance
with provided instructions and a minimum 20 cm spacing must be provided
between computer mounted antenna and person’s body (excluding extremities of
hands, wrist and feet) during wireless modes of operation.
 This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution
 Any changes or modifications not expressly approved by the
party responsible for compliance could void the authority to operate equipment.
iv