User Manual

Smart DY8962
BM3720A-KV600-Shaft
Motor Shaft
ASSEMBLY:
Install the spinner with PA2.5*
8mm screws.
Install the propeller.
Connect the elevator push rod
as shown.
Connect the rudder push rod
as shown.
1 2 3 4 5 6
7
8 9 10 11 12 13
15 16 17 18 19 20
14
Connect the aileron servos
with the Y wires.
DY8962
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
DECAL:
CENTER OF GRAVITY(C.G.)
DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT
Wingspan
Length
Flying Weight
Wing Area
Wing Load
Radio System
Power
Battery
: 1500mm (59.06in)
: 1300mm (51.2in)
: 1800g (63.6oz)
: 33dm²
: 54.5g/dm²
: 4 Ch TX and 7 Ch RX
: Brushless System
: LIPO, 2600 mAh, 14.8V
DY-6014 14.8V 2600mAh
25C Battery
DY-1007 9g Servo
DY-3003 Glue
SPARE PART LIST:
BM3720A-KV600
Brushless Motor
DYR-2001 2.4G Receiver
DYP-1019 13*6 Propeller
Smart-14 Decal
Smart-15
Plastic Tab
Smart-13 Blade Holder
Smart-12 Servo Horn
Smart-01 Fuselage Smart-02 Wing Smart-03 Elevator Smart
-04 Tail set
Smart-07 Landing Gear
Set
Smart-05 Spinner
Control Throw Setting Suggestion
Elevator Aileron Rudder
14.8V 2600mAh
Li-Po, 25C
(13x6)
ESC-40A
ESC-40A
Lithium-polymer Battery
2600mAh 14.8V
25C Discharge
Rechargeable Cells
Use li-po charger only
MOTOR
75 80
75 80
DYE-1004 40A ESC
DY-1009 17g Servo
１０
１２１１ １５ １８ １９１７１６１３ １４
２１ ４
19
７８ ９３
５
６
1
11
7
18
8
2
12
10
9
4
3
5
6
DYB-08 Pilot
Smart-06 Canopy Smart-08 Plastic Parts
Smart-09 Push Rod
Smart-10 Glass Fibre Tube
Smart-11 Steering Metal
Parts
Glue the pilot. Glue the canopy.
Open the canopy this way.
Glue the fuselage plastic parts.
Secure the tail section with
PM3*35mm screws.
Install the landing gear with
PM3*16mm screws.
Install the landing gear cover
with Double-sided tape.
Insert the fiber glass tubes
into the wings and Install the
wings onto the fuselage.
Glue the side force generator
(SFG).
Secure the front landing gear
with a hexangular screwdriver.
Insert the ø6*4*240mm fiber glass
tube into the horizontal stabilizers and
fuselage, then glue them together.
Glue the elevator U-shaped
rod as shown.
Connect the elevator and
rudder extension wire.
Insert the tail section into the
fuselage.
Secure the wings with PWA
2.6*8mm screws.
DY-3006 Motor Mount
Smart-16 Cockpit
Smart-17
Screw set