User Manual

Component Specifications
Installation
TM
Appearance: Black butyl core with 4 mil aluminum
constraining layer, self adhesive with release liner
Mass: 0.45lbs./ft.
2
(2.20kg/m
2
)
Adhesive Peel Strength: 42.6 lb./in. (74.8 N/cm)
Appearance: Black polymer 6" x 6" square Thickness: 1/4” (6.35mm)
Mass: 0.34 lbs. per 6” square (168 g per 152mm square) Density: 69.6 lbs./ft
3
(1120 kg/m
3
)
Rebound Resilience: <15%Tensile Strength Recommended Adhesive: super glue
TM
Thickness: 0.067” (1.7mm)
Temperature Range (Optimal Performance):
14 ºF to +140 ºF (-10 ºC to +60 ºC)
Temperature Range (Resistance):
-65 ºF to +300 ºF (-54 ºC to +149 ºC)
FOAM
Thickness: 1.5" (38.1mm) total
Mass: 0.16 lb/ft
2
(0.78 kg/m
2
)
Density: 2.0 lb/ft
3
(0.125 kg/m
3
)
Tensile Strength: 15 psi
Tear Strength: 1.9
Thermal Conductivity (R):
1.9 (hr-ft²-deg.F/BTU)
Standards:
Meets UL94 HF-1
Temperature Range (Resistance):
-40 ºF to +225 ºF (-40 ºC to +107 ºC )
DYNIL™
Appearance:
Black Flexivinyl Barrier
Color: Charcoal Gray
STC: 28
Mass: 1lb per square foot
Thickness: 0.09 inches
Temperature Range (Resistance):
-40 ºF to +220 ºF (-40 ºC to +105 ºC )
Standards:
Meets UL94-V0
Chemical Resistance:
Resistant to water and mineral oils
Damp with
Diffuse with
Decouple with
Before you start, make sure you have chosen the proper size
of the En-Wall Kit based on your wall thickness (4" or 6").
For retrofit installation, first remove the in-wall speaker.
Prepare the surface by wiping the dust, dirt and debris from
the area behind the in-wall speaker opening.
Place Dynamat Xtreme on a flat surface, and attach the
DynaXorbs to the aluminum face with the provided super
glue adhesive.
Fold the Dynamat Xtreme/DynaXorbs as needed to pass
through the in-wall speaker opening.
Remove the release liner and attach the Dynamat
Xtreme/Dynaxorbs assembly to the clean drywall making
sure that it adheres properly. (Be careful not to drop the
Dynamat Xtreme/DynaXorb in the wall cavity.)
Slide the SoundSnake through the hole and position one
end against a wall stud. Insert remainder of SoundSnake to
create a rounded corner enclosure (See picture on opposite
side). Position the speaker wire behind the SoundSnake
against the back wall. Finish by joining the ends of the
SoundSnake together.
Install (re-install) the in-wall speaker.
En-Wall kits are designed for easy retrofit or new construction
Dynil barrier between two layers of gray acoustic foam.