Manualshelf

Owner's Manual

ManualsBrandsDynamic ManualsHome FurnishingVenice I Edition DYN-6210-01 77" with 1-2 Person Capacity, 6 Carbon Heating Elements, Chromotherapy Lighting System and MP3 Auxiliary Connection
11121314151617181920
12
D. Installing the REAR PANEL
1. Remove the protection paper from the buckles on the REAR WALL PANEL. Place the REAR
WALL PANEL up onto the FLOOR PANEL. Next, attach the REAR WALL PANEL to the
RIGHT SIDE WALL PANEL and use the buckles to latch together. Do the same for the LEFT
SIDE WALL PANEL. (see Figure 10)
Figure 10
E. Installing the BENCH HEAT EMITTER PANEL and BENCH
1. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will need to slide the
BENCH HEAT EMITTER PANEL into place at an angle as indicated in the pictures below.
(see Figure 11)
2. Plug in the BENCH HEAT EMITTER connector to the corresponding inlet located on the right
side of the REAR WALL PANEL. Also plug in the FLOOR HEAT EMITTER PANEL connector
to the corresponding inlet on the left side of the REAR WALL PANEL.
3. Install the BENCH at an angle as seen in Figure 11. Then slide it over the horizontal bench
guides on the side panels. Slide the BENCH all the way in and against the REAR WALL
PANEL. Make sure to install the BENCH with the smooth and finished side facing upward. It
is optional to screw the BENCH down to the REAR WALL PANEL.