User's Manual

20
y Alert type: Set the alert type such as Ring only、Vib only, Vib. And ring, Vib. Then ring.
y Ring type: Set the ring type such as Repeat、Ascending、Beep once.
y SIM1 incoming call: Set the ringtone for the SIM1 incoming call. You can also select ringtone from T card.
y SIM2 incoming call: Set the ringtone for the SIM2 incoming call. You can also select ringtone from T card.
y Ringtone volume: Set the ringtone volume of the incoming call.
y SIM1 message: Select the ringtone for the SIM1 message. You can also select the ringtone from T card.
y SIM2 message: Select the ringtone for the SIM2 message. You can also select the ringtone from T card.
y Message volume: Set the volume for message ringtone.
y Keypad: Select the ringtone for keypad. Human voice tone, Click, Tone
y Keytone volume: Set the volume for the keypad.
y Power on: Select the ringtone for the power on.
y Power off: Select the ringtone for the power on.
y System alert: On /off the system alert.
¾ Reset: Reset the setting to the default.
After plugging in the headset, ringtone will output from the headset as well as the phone, when there is incoming call or message.
8.6. Network settings
You can set up the phone network with this function.
SIM1/SIM2 network settings
¾ Network selection: choice the modes of searching the phone network, including Auto and Manual modes.
8.7. Security settings
You can manage your phone safely with this function.
The phone lock password, SIM card password and PIN2 support 4-8digit numbers, do not support other characters. The original password of the phone when
leaving the factory is 1122. The password and PIN2 and SIM card are provided by the network operator. When the PIN/PIN2 is input wrongly in successively
three times, the SIM card will be locked.
The PUK /PUK2 are required to input if you want to unlock the SIM card. The PUK/PUK2 is provided by the network operator. If the PUK is input wrongly in
successively 10 times, the SIM card will be locked and discarded permanently.
8.7.1. SIM1 security
y PIN lock: open or close the PIN lock function. When PIN lock is launched, the PIN shall be input upon each power-on.