User's Manual
8
3. Begin to Use
3.1 Install SIM Card and Battery
Please be sure to disconnect the phone with the adapter before disassembling the battery.
This version is a dual-card dual-standby phone which can be inserted with 2 SIM cards. Both SIM cards
can register onto an identical network. Each SIM card is included in the socket generally. The SIM card
1 is inserted in the Socket 1 and SIM card 2 in Socket 2. You should be careful to use, insert and
disassemble the SIM card because the contact of the SIM card is easy to be scraped or bent to
damage.
1 Disassemble the battery cover.
2 Disassemble the battery.
3 Slide the SIM card into the socket.
4 Insert the battery.
5 Cover the battery.
3.2 Charge the Battery
The phone will release the warning tone displaying the insufficient battery capacity with the indication of
the empty battery icon when the battery capacity is lower. Under this case, the phone may not be used
in partial functions.
The phone will power off automatically when the battery capacity is too lower. Please charge the
battery.
The battery icon on the screen will flash when the phone is being charged. After completion of charging,
the full battery icon will
display on the screen. The charging animation will be displayed on the screen
when the phone is being charged under the power-off state. After completion of charging, the screen
will display the prompt system of finishing charging. Under the standby mode, it takes 2-3 hours to
charge the battery.
Unpack the rubber protective cover on the charging interface and connect the adapter with the phone.
1. Insert the adapter in AC electric outlet.2. Open the rubber protective cover of the charging
interface of the phone and connect the adapter to the phone.
3. The symbol indication of charging the battery appears on the screen. (the symbol indication of
charging the battery can appear after waiting for a few minutes if the battery capacity is exhausted).
4. Pull the adapter apart from the power supply socket and then pull the adapter out of the phone after
completion of the charge.
This is the principle of the battery.
z Not charging: If the phone power is supplied by the battery 1 in default, the battery 2 will be