User Manual

Thank you for choosing Dynamite's 12 Volt
DC 10 Amp Power Supply. Although this
product is designed for ease of use it is not
a toy and requires some adult supervision.
This manual contains basic instructions
for safety, operation and maintenance. It’s
essential to read and follow all the instruc-
tions and warnings in this manual, prior to
assembly, setup or use, in order to operate
correctly and avoid damage or injury.
This is a sophisticated electronic product
that must be operated with caution and
common sense. Failure to operate this
product in a safe and responsible manner
could result in injury or damage to the
product or other property. This product is
not intended for use by children without
direct adult supervision.
Horizon Hobby shall not be liable for any
loss or damages, whether direct, indirect,
special, incidental, or consequential, aris-
ing from the use or misuse of this product
or any product required for operating it.
(See warranty and limits of liability)
• Carefully read and follow the directions
and warnings associated with this power
supply and the battery charger being
used.
• Carefully observe correct polarities at all
times.
• Keep away from liquid, flammable
chemicals and moisture.
• Keep all chemicals, small parts and
anything electrical out of the reach of
children.
1. Plug AC power cord into a 110V
wall outlet.
2. Attach the banana plugs of the charger
into the proper polarity of the banana
plug jacks in the power supply (red
(+ Positive) banana plug into red
terminal of the power supply and
black (– negative) to black).
NOTE:
If your charger does not have
bannana plugs (DLR2000) you may
purchase them from your local
hobby shop.
3. Once properly attached, the charger will
be powered.
If the power supply is overloaded (more
than 10 amps), the automatic protection
circuit will stop the operation of the power
supply until the overload condition
is removed.
The cooling fan keeps the internal compo-
nent cool and allows for the smaller profile
of the power supply. The fan will operate
whenever the power supply is connected to
AC power.
The output voltage is preset at 13 volts
DC. It can be adjusted from 10-14 volts
DC for customized applications by adjust-
ing the potentiometer located right of the
power indicator LED. Check the instruction
manual for the item you wish to power to
confirm proper source voltage.
INSTRUCTIONS
Operating Instructions
Overload Protection
Cooling Fan Operation
DC 12V 10Amp
Power Supply
Voltage Adjustment
Safety Precautions