User Manual

14
BATTERY MEMORY
The charger can store up to 10 settings for specifi c batteries.
[ BATT MEMORY X ]
ENTER SET->
LiPo
BATT TYPE
BATT VOLTAGE
14.8V(4S)
CHARGE CURRENT
2.0A
DISCHRG CURRENT
1.0A
DISCHG VOLTAGE
3.0V/CELL
4.20V
TVC=YOUR RISK!
SAVE PROGRAM
ENTER
The following images show programming a Li** battery, options will vary
with Ni** and Pb battery types.
1. Press the Batt / PROG Stop button to access the root menu. Press the DEC
or INC button to scroll through the main menu screens until you reach
BATT/PROGRAM BATT MEMORY.
2. Press the ENTER / Start button to enter the Battery Memory settings
3. Press the DEC or INC button to select the battery memory (1-10) you wish
to confi gure.
4. Press the ENTER / Start button to go to the fi rst page of settings for the
selected battery memory.
5. Press the ENTER / Start button to edit the parameter.
6. Press the DEC or INC button to increase or decrease the value of each
page. When the value is fl ashing it can be adjusted with the increase or
decrease buttons.
WARNING: TVC sets the maximum voltage allowed for each cell in
lithium charge modes. We recommend leaving the TVC value at 4.2V.
Only raise the voltage above 4.2V when charging LiHV batteries.
7. Press the ENTER / Start button again to save the selection. When all the
values on the page are solid and do not fl ash, pressing the increase or
decrease buttons will move to the next value in the battery memory.
8. Complete the menu options for the battery memory, and press the ENTER /
Start on the Save Program page to save the battery memory. The changes to
the battery memory will not be saved if this option is not selected.
9. Press the Batt / PROG Stop button to return to the main menu.
10. To select a battery memory, access the BATT/PROGRAM BATT MEMORY
screen, select the memory number desired and press the ENTER / Start
button to start the charge.
11. Re-load the factory settings in the SYSTEM SETTINGS menu to reset the
battery memory slots.