User manual

Dynamix DW-2/4 FXO SIP Gateway User Manual

Analyzing!! Please wait a moment……..

Frequency 1 : 480

Frequency 2 : 620

Frequency 3 (2623) is more than 1000, please ignore it.

0.25sec on 0.25sec off

usr/config$

Note:

1. About the tone detection or tone recording for FXO unit, two

extension or PSTN line is necessary.

2. Records disconnect tone: Please read the procedure of recording

disconnect tone file from the web site in application.

3. The values of disconnect tone and ring back tone will not write in

flash automatically. Please use the command in “tone” to write in

the tone table.

The Procedures of recording the disconnect tone

Before you start

Prepare two PSTN lines, which connect with the Line 1 and Line 2 port.

Please record the disconnect tone just follow the stage as below

1. Please enter the command before you record the disconnect tone

record -tone

2. Make a call from PSTN side into Line 2 port.

3. You will get a greeting when the call enters the gateway.

4. Pease dial the number of the Line 1 port.

5. Users will get the dial tone from the PSTN side and please dial the number

to contact with another person.

6. Please drop the call from the calling aide and the called side could get the

disconnect tone from the Line 2 port.

7. When you get the disconnect tone from the Line 2 port, press <R> and

<ENTER> buttons to start recording the disconnect tone.

8. Please hang up another side if users get the message as below Analizing!!

Please wait a moment…