Tiger 2Plus (4LAN) ADSL 2+ Router User Manual V 1.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual CONTENTS 1.OVERVIEW ........................................................................................................................................3 1.1 ABOUT ADSL........................................................................................................................3 1.2 ABOUT ADSL2/2+.................................................................................................................3 1.3 FEATURES .......................
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 1.OVERVIEW 1.1 ABOUT ADSL An ADSL MODEM is a broadband Internet access device, which utilizes the high frequency segment of the phone line to transmit high-speed data without affecting the voice transmission. The frequency of the ADSL signal is higher than that of voice, so voice and ADSL signal can coexist in one line by using a splitter to insulate each from the other. ADSL data transfer adapts the asymmetry model.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 2 SPECIFICATION 2.1 INTERFACE INTRODUCTION 2.1.1 INDICATOR AND INTERFACE Table 2.1 ITEM Name State introduction ⑧POWER A steady red light means the power connection works properly ⑦DSL Yellow, shows DSL line status. ⑥INTERNET Green, Flashing means the Modem is transmitting or receiving data ⑤LAN Green, Indicates status of connection to the PC network card ①LINE Connected with phone line or “ADSL” port of the splitter.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 2.1.2 SPLITTER SPEC Table 2.2 Interface Introduction LINE Connected with telephone line ADSL Connect with the LINE port of the ADSL Modem using telephone line provided. PHONE Connect with telephone 2.2 HARDWARE CONNECTION Introduction： 1、 Use a telephone cord to connect the LINE port of the splitter with the RJ-11 port (the phone jack) on the wall.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 3.CONFIGURATION 3.1 DEFAULT CONFIGURATION ADSL MODEM has pre-configured with the VCI/VPI which is in common use. The default dial-up mode is bridge encapsulation. For bridge mode, no need to configure any more parameter. However, the third party dial-up software is needed for connection with the Internet 3.2 COMPUTER CONFIGURATION The default IP address for ADSL MODEM is: 192.168.1.1; The Subnet Mask is：255.255.255.0.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 3.3.2 SAVE SETTING After getting through each page for parameters setting, click “Save” or “Save apply” to store the value in ADSL MODEM. Briefly, we named “Save”. Note： When you save the settings, the web page will be refreshed slowly, please wait it finished. After you save the settings, it will take effect until next reboot. Some settings only take effect after rebooting the router. 3.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual Click on the next connection which you want modify. Press “Edit” button, enter the configure guide, as Figure 3.3 z Figure 3.3 The value for VPI/VCI is assigned by your ISP. After inputting the PVC value, press “Next” into “connection type”. As Figure 3.4. Figure 3.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual The Modem supports five ADSL protocol modes. Choose the protocol which is appointed by ISP and PVC encapsulation, click “Next” enter to the protocol configure. Below, we introduce the configuraion of the five protocol modes.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual Figure 3.6 Note：When you use bridge mode, please close “DHCP SERVER”, the result as Figure 3.7 Figure 3.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 3.4.3 PPPOE CONFIGURATION PPPoE is also known as RFC 2516. It is a method of encapsulating PPP packets over Ethernet. PPPoA is also known as RFC2364 and named as Peer to Peer Protocol over ATM. As PPPoE, it also has all the features of PPP. Although it’s based on ATM protocol, the setting of all the other parameters is similar with PPPoE. So we only introduce PPPoE in detail here. In Figure 3.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual how long the connection will be disconnected in the absence of traffic. If the value is 0, connection will not be disconnected. Press “Next step” when configuration is finished. The following operation is same with Figure 3.5. Notice that PPPoE mode does not work until the modem is reset. 3.4.4 STATIC ADDRESS In Figure3.4, select MAC Encapsulation Routing (MER), press “Next”, and the configuration can be queried from your ISP, the result as Figure3.9.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 4 OTHER CONFIGURATION 4.1 LAN CONFIGURATION Configuration of Modem’s IP address and password 4.1.1 CONFIGURATION OF MODEM’S IP ADDRESS As a network device, ADSL Modem has its own IP address and MAC address. The factory sets the MODEM, at a default IP address of 192.168.1.1 and subnet mask of 255.255.255.0. The user can configure these addresses through the “LAN” on “Configuration” like this: For example, change IP address to “10.10.10.10”.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual • Define the “Start IP address” and the “End IP address” of DHCP server (for example, from 192.168.1.2 to 192.168.1.254). • Input the value of lease (Measured by the second, 0 indicates permanently valid). As Figure 4.2, open DHCP server, computer will set the IP Address of network card with one of the address 10.10.10.11 ∼ 10.10.10.254. Figure 4.2 Note：When you use the DHCP Server, please pay attention to having multi-DHCP Server in one LAN. 4.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual 5. TROUBLESHOOTING 5.1 UNABLE TO ACCESS INTERNET 5.1.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual Note 1：The precondition is that LAN settings in the modem has not been modified. Note 2：We usually start command line mode in Windows 2000 as follows: click on the “RUN” item of Windows Start Menu, input characters “cmd” in the input box popped up with an “Enter”. The window subsequently popped up is the command line window. Note 3：The returned values of ping command in the following format show the standard of “reachable” Figure 5.
Tiger 2Plus (4LAN) ADSL 2+ Router ̶ User Manual ANNEX：SHIPPING LIST ADSL MODEM Splitter User Manual Power Supply Cable Cat5 RJ45 Telephone Line Warranty Certificate ×1 ×1 ×1 ×1 ×1 ×2 ×1 Page 17 Total 17 Pages
