Quick Start Guide

DynaPredict Manual - Quick Start - Version 3 – September 2022
Public Document
11
surface. Once this is done, tighten the screw and spring washer*
supplied with the product, applying a tightening torque of 11Nm.
* Use of spring washer is critical to achieving reliable results.
Figure: Screw Mounting
Adhesive Mounting
Glue mounting can be advantageous in some cases:
- Mounting on curved surfaces, that is, where the DynaLogger
base will not be fully supported on the surface of the measure-
ment spot;
- Mouting in components that do not allow drilling of at least
15mm;
- Installations on in which the DynaLogger's Z axis is not posi-
tioned vertically in relation to the ground;
- Installations of DynaLogger TcAs and TcAg, since these
models only allow glue mounting.