Quick Start Guide

DynaPredict Manual - Quick Start - Version 3 – September 2022
Public Document
4. Positioning the DynaLoggers
08
With these procedures completed, the user can finally go into
the field to perform the physical installation of the sensors on the
machines and components registered in the asset tree.
After finishing these procedures, the user can finally go into the
field and perform the physical installation of the sensors on the
machines and components registered in the asset tree.
More details regarding this process are present in the following
articles of this section.
Before carrying out the physical installation of the sensors on
the machines, here are a few recommendations:
The first step, in the case of explosive atmospheres, is to
consult possible restrictions on the product datasheet.
Regarding to vibration and temperature parameter
measurements, these should be taken on rigid parts of the
machinery. Installation on fins and in fuselage regions should be
avoided, as these may present resonances, attenuate the signal,
and dissipate heat. In addition, the device should preferably be
positioned on a non-rotating part of the machine.
Since the DynaLoggers take readings on three orthogonal axes, they
can be installed in any angular direction. However, it is
recommended that one of the axes (X,Y,Z) be aligned with the
machine shaft.