Quick Start Guide

DynaPredict Manual - Quick Start - Version 3 – September 2022

Public Document

Figure: Axes orientation

Left: DynaLogger TcA+. Right: DynaLoggers HF and HF+

The images above show the orientation of the DynaLogger

axes. This can also be seen on the label attached to the devices. The

correct positioning of the device should take into account the axis

and orientation of the machine.

1. The DynaLogger must be installed in a rigid part of the ma-

chine, avoiding regions that may present localized resonance;

2. Preferably, the DynaLogger should be centered in relation

to critical components, such as bearings;

3. It is recommended to keep the DynaLogger at a ﬁxed point,

i.e., to deﬁne a deﬁnite installation for each device in order to

obtain repeatability in measurements and a history of quality data;

4. It is recommended to verify that the surface temperature of

the monitoring point is within the recommended limits (-10ºC to

84ºC) for the use of DynaLoggers. Using the DynaLoggers at tem-

peratures outside the speciﬁed range will void the product warran-

ty;

Regarding the actual installation locations, we have created a

suggestion guide for the most common machine types. This guide

can be found on our Support page (https://support.dynamox.net),

in the section “Applications and good monitoring practices”.