User's Manual

User Manual
Mouse Operating steps：
The wireless mouse uses two AA batteries.
a) Open the battery cover at the bottom of the mouse.
b) Insert the two AA batteries.
c) Replace the cover after the batteries are installed.
2、 Plug in the receiver to USB port on your computer. When
receiver is ready, LED is on.
3、 Press three buttons of the mouse (left/right/roller) at the same
time to change the sensor speed DPI. (1000DPI-2000DPI.)
4、 Press the button at the bottom of the mouse, new ID code setting
has been completed to avoid another user interference.
5、 Sensor 4 stages of batteries consuming design can offer more
than two months of normal office use.
1)Work stop： stop flash 。
2)Stand by(1)：flash quickly。
3)Stand by(2)：flash quickly。
4)Sleeping： flash slowly。