User's Manual

FBP205 User Manual
This module is intended under the following conditions：
1. This module is certified pursuant to Part 15 rules section (15.247).
2. This module is limited to host model number: 67301, 67401, 64909, 64428/ Brand: DynaScan
3. This module has been approved to operate with the antenna types listed below, with the
maximum permissible gain indicated.
Frequency Band
Antenna Type
Gain(dBi)
2400-2500MHz
PIFA
-3.04
5150-5850MHz
PIFA
-2.31
Information on test modes and additional testing requirements：
This module is restricted to integration into hosts for indoor use only.
Be limited the operation channels in channel 1-11 for 2.4GHz band.
The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
The information on how to configure test modes for host product evaluation for different
operational conditions for a stand-alone modular transmitter in a host, versus with multiple,
simultaneously transmitting modules or other transmitters in a host can be found at KDB
Publication 996369 D04.
According to KDB 388624 requirements we will retain control over the final installation of the
modular such that compliance of the end product is assured.
Clear and specific instructions describing the conditions, limitations and procedures for third parties
to use and/or integrate the module into a host device (see Comprehensive integration instructions
below). Resolve: Supply example as follows:
Installation Notes:
(1) When connect module to the host device, the host device must be power off.
(2) Make sure the module pins correctly installed.
(3) Make sure that the module does not allow users to replace or demolition.
(4) Host approval is limited in mobile condition.
(5) Labeling are pre-checked by modular vendor before marking.
(6) Output power, and spurious emission are checked as always prior to permission to sign before
marking.