User's Manual

This module is intended under the following conditions：
1. This module is certified pursuant to Part 15 rules section(15.247).
2. This module is limited to host model number: 66502, 66901 / Brand: DynaScan
3. This module has been approved to operate with the antenna types listed below, with the
maximum permissible gain indicated.
Frequency Band
Antenna Type
Gain(dBi)
2400-2483.5MHz
PIFA
0.87
Information on test modes and additional testing requirements：
This module is restricted to integration into hosts for indoor use only.
Be limited the operation channels in channel 1-11 for 2.4GHz band.
The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
The information on how to configure test modes for host product evaluation for different
operational conditions for a stand-alone modular transmitter in a host, versus with multiple,
simultaneously transmitting modules or other transmitters in a host can be found at KDB
Publication 996369 D04.
Additional testing, Part 15 Subpart B disclaimer：
Appropriate measurements (e.g. 15B compliance) and if applicable additional equipment
authorizations (e.g. SDoC) of the host product to be addressed by the
integrator/manufacturer.
This module is only FCC authorized for the specific rule part 15.247 listed on the grant, and the
host product manufacturer is responsible for compliance to any other FCC rules that apply to
the host product as being Part 15 Subpart B compliant.
The user manual of the end product should include：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
The antenna(s) used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.