Specifications

English - 11 -
8.4.- ALARM FUNCTION:
Hold down the programmed side key with this function, the transceiver will sound alarm tone and
send “ANI” identification code to others transceiver of their group.
8.5.- EMERGENCY CHANNEL:
Press the [#T-R] key, in any case the transceiver can call up the emergency call
channel, and the display shows “CAL”.
8.6.- REVERSE FREQUENCY FUNCTION:
This function is possible only when you are linked to a repeater. It permits to invert the TX
frequency with the RX frequency.
In channel/frequency mode, hold down the [#T-R] key for two seconds until “T*R”
appears on the display.
The display shows the “REV” icon. Repeat the same procedure to return to the normal mode
operation.
8.7.- SCANNING:
The scan function is very useful to monitor the channels before transmitting.
1.- Scan channels or frequency:
In channel/frequency mode, press the [MENU] + [1SCAN] key, and then press the [ENTER] key to
start the scan from the channel or frequency in use. Whenever any signal is detected, the transceiver
will suspend the scan for 5 seconds. The transceiver will then continue to scan unless you press the
[PTT] or [ENTER] key to end scanning.
2.- Priority channel scan:
Priority scan is to scan the priority channel firstly and then scan other channel, if you set priority
channel 1, it will scan 1-2; 1-3; 1-4; and continue. In channel mode, press the [MENU] + [2PRI]
key, and then press the [ENTER] key to scan the priority channel. The transceiver begin to scan
priority channel. When any signal is detected, the transceiver will suspend the scan for 5 seconds. It
will then continue to scan unless you press the [PTT] or [ENTER] key to end scanning.
3.- Subtone scan:
In the frequency mode, press the [MENU] key and rotary the selector knob to select the “021 CTC
• S?” menu or the “022 DCS.S?” menu. Then press the [ENTER] key to enter the “CTCSS” (50
groups) scan or “DCS” (105 groups). When the transceiver scan to the same subtone or code, open
the “Squelch” and exit scan.
8.8.- SELECT SCAN TYPE:
Press the [MENU] key and rotate the selector knob until the display shows “013 SCANS”. Press the
[ENTER] key and turn the selector knob again to select the scan type “TO/CO/SE”.
- TO: Even though the transceiver stops on a busy channel or frequency and it will continue
scanning the other channels or frequency.
- CO: The transceiver stops on a busy channel or frequency until there is no activity, and then the
transceiver begins scanning the other channels.
Παύλος Μεϊµάρης Ελπίδος 34 (ΒΑΟ) Συκιές, Θεσσαλονίκη τηλ 2310.634.513, 6977.38.38.73
URL:
http://www.meimaris.com -
Εmail: [e-mail]
Παύλος Μεϊµάρης Ελπίδος 34 (ΒΑΟ) Συκιές, Θεσσαλονίκη τηλ 2310.634.513, 6977.38.38.73
URL:
http://www.meimaris.com -
Εmail: [e-mail]