Specifications

English - 19 -
11.14.- WIDE AND NARROW BAND SELECTION:
1.- Press the [MENU] key.
2.- Turn the selector knob until “N/W” (menu 014) is displayed.
3.- Press the [ENTER] key.
4.- Turn the selector knob to select from “NARROW or WIDE”.
5.- Press the [ENTER] key.
6.- Press the [VFO/MR] key to exit.
11.15.- REPEATER SHIFT:
This function is used for communications through repeater.
To activate this function, follow these steps:
1.- Press the [MENU] key.
2.- Turn the selector knob until “SHIFT” (menu 015) is displayed.
3.- Press the [ENTER] key.
4.- Turn the selector knob and select the repeater shift. You can choose amongst the following
options “+”, “-” and “0”.
5.- Press the [ENTER] key again.
6.- Press the [VFO/MR] key to exit.
To select the repeater shift, you can also use the fast menu. Press the [MENU] key, then press the
[*LOCK] key and follow the procedure above described.
11.16.- REPEATER SHIFT ADJUSTMENT:
1.- Press the [MENU] key.
2.- Turn the selector knob until “OFFSET” (menu 016) is displayed.
3.- Press the [ENTER] key.
4.- Turn the selector knob and select the repeater shift.
You can also enable it by enter the frequency directly on the keypad
5.- Press the [ENTER].
6.- Press the [VFO/MR] key to exit.
11.17.- SELECT “CTCSS” AND “DCS” ON TRANSMITTING AND RECEIVING:
1.- Press the [MENU] key.
2.- Turn the selector knob until “C-CDC” (menu 017) is displayed.
3.- Press the [ENTER] key.
4.- Rotate the selector knob and select the desired “CTCSS” tone, or press the [*LOCK] key to
select “DCS” code. While selecting the “DCS” codes, if you press the [#T-R] key, you will select
the normal (N) or inverted (I) “DCS” codes.
5.- Press the [ENTER] to confirm.
You can use keypad or software to input or program a non-standard “CTCSS/DCS”.
11.18.- SELECT “CTCSS” AND “DCS” ON RECEIVING:
1.- Press the [MENU] key.
2.- Rotate the selector knob until “R-CDC” (menu 018) is displayed.
3.- Press the [ENTER] key.
4.- Turn the selector knob and select the desired “CTCSS” tone, or press the [*LOCK] key to select
“DCS” code. While selecting the “DCS” codes, if you press the [#T-R] key, you will select the
normal (N) or inverted (I) “DCS” codes.
Παύλος Μεϊµάρης Ελπίδος 34 (ΒΑΟ) Συκιές, Θεσσαλονίκη τηλ 2310.634.513, 6977.38.38.73
URL:
http://www.meimaris.com -
Εmail: [e-mail]
Παύλος Μεϊµάρης Ελπίδος 34 (ΒΑΟ) Συκιές, Θεσσαλονίκη τηλ 2310.634.513, 6977.38.38.73
URL:
http://www.meimaris.com -
Εmail: [e-mail]