Owner`s manual

Skimmer / Filter
Location
Baron 3000
Skimmer / Filter
Location
Filter Location
5000 Top Side Control Instructions
20
17
Summary of control panel
parameters
FSxx Filter cycle start time
Fdxx Filter cycle duration
FFxx Filter cycle frequency
ESxx Economy mode start time
Edxx Economy mode duration
Tu X Temperature unit
LocX Control pad lockout
This function allows you to prevent unauthorized
parameter setting of the unit. This feature is especially
helpful when young children have access to the keypad.
There are two modes you can choose from: Full lock or
Partial lock. Full lock means that all keypad functions are
locked. Partial lock means that the basic functions of the
spa will remain accessi-ble (pumps, blower and light), but
it will be impossible to change the temperature Set Point,
to override the Economy mode or to enter the
Programming mode.
When control pad is locked, the "Lock" icon will be
displayed.
Locking your digital control pad:
 1- Press and hold Pump 1 key for
 5 seconds.
 2- The display will show LocP, with "P"
 representing Partial lock.
 3- Release the key and the keypad will
be
 in Partial lock mode. Keep key
pressed
 down for 5 more seconds if you want
 to be in Full lock mode. The "LocF"
 message will then be displayed.
Digital control pad
LocP
LocF
Inverted display
Press and hold Pump 2 for 5 seconds to invert the display.
Note that the ˚F or ˚C icon is not displayed in reverse
mode. Follow the same procedure to return to default
mode. If a power-up occurs, the display always returns to
Economy
Press Econo key to switch from Normal mode to Economy
mode. To save energy, the Economy mode Set Point is
20˚F (11˚C) below the Normal mode Set Point.
 The "Economy Mode" icon lights up when Economy
 mode is on.
There are 3 available Economy operating modes:
noEc: No Economy mode
Ec 1: Economy mode on during a programmed
 number of hours (see Steps 5 & 6*)
Ec 2: Economy mode always on
Selecting the desired Economy mode:
 1- Press and hold Econo key for
 more than 2 seconds.
 2- The display will show the current
  mode (noEc, Ec 1 or Ec 2).
 3- Keep key pressed down until the
  desired mode is displayed.
After 5 seconds, the new setting will be programmed.
Ec 1
noEc