Owner`s manual

Priming Pump For Electric Packs
Turn off power at the breaker.
It is important to make sure that all of the air is out of the equipment pack
before operating. To do this, follow the procedures below:
The power pack system is located under the foam skirt. The equipment
can be serviced by simply opening the door.
Set thermostat, located on top side control panel, to desired temperature and
continue heating until desired temperature has been reached. Depending
on equipment and outside conditions, this will normally take 8 to 10 hours.
Make sure the gate valves are open.
Fill the spa with water going through the filter.
Turn the power on at the breaker.
Start the pump on Lo-speed and water will start circulating within
one to two minutes. (The pump is self-priming). If water does not circulate,
turn off the power and make sure all gate valves are open.
Restart the pump. Within one to two minutes, it should be primed.
General Pre-Operation Instructions
WARNING: Do not run spa with gate valves closed or run pump with
no water circulating in spa for long periods. This could damage
the spa equipment.
Ozonator
Control Pack Gate Valve Hose Bib 5.0 hp Pump
Foam Insulation
11
Flow Thru
Heater