Operating instructions

Swim Spa Operator’s Guide

WINTERIZING YOUR SPA

WARNING!

In areas of the country where the temperatures drop below 32° F (O˚ C), it is important to

follow these directions:

When winterizing the spa, we recommend putting RV Antifreeze in the spa and running it before

draining the spa.

Note: Freeze ups or damage caused by freezing are not covered under warranty!

NOTE!

SPRINGTIME START-UP

If your swim spa has been winterized. The Manufacture highly recommend that you contact an

authorized dealer to restart your swim spa. This following is an outline of the procedures involved.

• Make sure all o-rings for pumps are in place and undamaged.

• Make sure all the ﬁttings that loosened are re-tighten.

• Replace all jet ﬁttings, pump drain plugs, hose bib drains, and bleeder valves.

• Fill the swim spa, with water in a normal way,

• Run the jets on high for about 15 minutes.

• Drain the water.

• Put the ﬁlters back in.

• Reﬁll the system and treat chemically as one would after a normal water change.

For more information about Winterizing your system, or restarting a winterized system, please

contact your local Authorized dealer.

If the spa is not going to be used, drain completely. Be sure all water is removed. Break or

loosen unions at each end of pump to ensure water from pump area is removed. Remove

pump freeze plugs if so equipped. Using a shop vacuum, vacuum all jets thoroughly to remove

any water left over in the plumbing lines.

Do not turn unit off with water in the spa. Frozen water may rupture plumbing. Freeze damage

repairs are not covered under warranty.

Remove and clean ﬁlter cartridge. Store cartridge in a secure place to prevent freezing. If the

spa is going to be used, maintain normal operating procedures and ensure cover is in place

when possible.