Operating instructions

Swim Spa Operator’s Guide

SWIM SPA TERMINOLOGY

GATE VALVES

Are installed for shut off/on water supply from heater or pump for service. For normal swim spa

operation valves should be in the open position (handle extended is open).

MAIN PUMP

This produces water ow through heater and main jets. Also used for ltration. Can be controlled

as desired by pressing the pump or pump 1 button on your topside control panel. Refer to quick

reference card for ltration frequency and duration.

SECONDARY PUMP (on select models)

This produces water ow through secondary group of jets. Can be controlled by pressing the pump

2 button on your topside control panel.

THIRD PUMP (on select models)

This produces water ow through third group of jets. This pump will be a high speed only. Can be

controlled by pressing the pump 3 button on your topside control panel.

CIRCULATION PUMP (on select models)

If equipped, this pump is controlled during ltration and heating only, by the topside control

conguration. Refer to quick reference card for ltration frequency and duration.

OZONATOR (on select models)

If equipped, will run for 45 minutes during ltration cycle. Helps reduce chemicals/santizier use.

Automatically cuts-off if any user buttons are pressed on topside control; will reactivate during the

ltration cycle.

Open

Closed