Operating instructions
Swim Spa Operator’s Guide
WINTERIZING YOUR SWIM SPA
WARNING!
In areas of the country where the temperatures drop below 32° F, it
is important to follow these directions:
When winterizing the swim spa, we recommend putting RV antifreeze in the swim spa and run-
ning it before draining the swim spa.
1) If the swim spa is not going to be used, drain completely. Be sure all
water is removed. Break or loosen unions at each end of pump to en-
sure water from pump area is removed. Remove pump freeze plugs
if so equipped. Using a shop vacuum, vacuum all jets thoroughly to
remove any water left over in the plumbing lines.
2) Do not turn unit off with water in the swim spa. Frozen water may rupture
plumbing. Freeze damage repairs are not covered under warranty.
3) Remove and clean lter cartridge. Store cartridge in a secure place
to prevent freezing. If the swim spa is going to be used, maintain normal
operating procedures and ensure cover is in place when possible.
Note: Freeze ups or damage caused by freezing are not covered
under warranty
!
NOTE!
SPRINGTIME START-UP
If your swim spa has been winterized, the Manufacturer highly recommends that you contact an
authorized dealer to restart your swim spa. The following is an outline of the procedures involved.
• Make sure all o-rings for pumps are in place and undamaged.
• Make sure all the ttings that loosened are re-tighten.
• Replace all jet ttings, pump drain plugs, hose bib drains, and
bleeder valves.
• Fill the swim spa with water in a normal way,
• Run the jets on high for about 15 minutes.
• Drain the water.
• Put the lters back in.
• Rell the system and treat chemically as one would
after a normal water change.
For more information about winterizing your system, or restarting a winterized system, please
contact your local Authorized dealer.
51