Operating instructions

Swim Spa Operator’s Guide
TROUBLE SHOOTING GUIDE (CONT.)
Note: These motors will feel hot to the touch. This is normal. The Overheat Sensor will
turn the motor off if there is an overload or high temperature problem.
Swim spa is leaking
Probable Cause #1 ........ Loose connection.
Action............................. Hand tighten all disconnects and ttings. Check joints and unions.
Motor does not run
Probable Cause #1 ........ No power to motor.
Action............................. Check power switches and circuit breakers. Check motor plug where
plugged into control box.
Probable Cause #2 ........ Pump jammed from foreign matter in impeller.
Action............................. Call dealer for recommended action.
Probable Cause #3 ........ Motor overheats on hot days while ltering.
Action............................. Reprogram your controls to cycle during the coolest parts of the day and
on shorter cycles. (see programming instructions).
Motor runs hot
Probable Cause #1 ........ Pump ran dry.
Action............................. Call dealer for recommended action.
Probable Cause #2 ........ Restricted suction lines.
Action............................. Make sure all valves are open/clear suction of debris.
Probable Cause #3 ........ Improper ventilation
Action............................. Insure that vents on side of swim spa are free and clear of any debris or
landscaping. Swim spa should also be located an adequate distance
from any
walls or fencing for good ventilation.
NOTE!
53