Service manual

Removing the Monitor Board and SpO2 Modules

9650-0801-01 Rev. A ZOLL Propaq MD Service Manual 63

Removing the Monitor Board and SpO

Modules

Tool Required

• # 1 Phillips screwdriver with torque capability

Setup

• This procedure should be conducted on a static mat.

• Wear a wrist strap to ground during the procedure.

• Complete these procedures in the following order before performing this procedure:

1. “Removing the Handle” on page 49

2. “Removing the Printer Module” on page 50

3. “Disassembling the Main Unit” on page 52

4. “Removing the Front Enclosure Module” on page 55

5. “Removing the Display Module” on page 57

Note: After replacing the Monitor Board and/or SpO

modules, see Chapter 4, "Resetting

Life Cycle Counters" to reset the life cycle counter for the module.

To reinstall the monitor board and/or SpO

modules, reverse the steps.

Monitor Board and/or SpO

Disassembly

1 Remove the EtCO2 anti-conductive shield

that lies on top of the unit.

2 Remove six (6) screws to release the

monitor board in the areas illustrated.

Note: During reassembly, torque screws to

6 in-lbs.

shield