User guide

ManualsBrandsDynatek ManualsFor motorcycles2002-2005 Yamaha Road Star Warrior

Dynatek • 164 S. Valencia St. Glendora CA 91741

www.dynaonline.com 800.928.3962

User Manual

Parts List

FI Controller

Installation Guide

Wire tap

Wire ties

Velcro

Strip

Alcohol Swab

2002-2005 Yamaha Road Star

Warrior

Part Number DFCM-7

2801197 REV. 7-05-05

Congratulations on your purchase of this Dynatek product.

Please take a moment to read these instructions completely before

installing the FI controller. The installation will only take a few minutes,

but proper setup for your specific bike will take longer

Summary of content (5 pages)

PAGE 1
2801197 REV. 7-05-05 User Manual 2002-2005 Yamaha Road Star Warrior Part Number DFCM-7 Congratulations on your purchase of this Dynatek product. Please take a moment to read these instructions completely before installing the FI controller. The installation will only take a few minutes, but proper setup for your specific bike will take longer Parts List FI Controller Installation Guide Wire tap Wire ties Velcro® Strip Alcohol Swab Dynatek • 164 S. Valencia St. Glendora CA 91741 www.dynaonline.
PAGE 2
Installation Remove the seat. Locate the ground strap that goes from the battery negative terminal, to the frame. Unbolt this at the frame, add the FI Controller ground wire(black wire with ring terminal) to this bolt, and reinstall the bolt. STEP 1 STEP 1 Mount the FI Controller in the proper location. STEP 2 STEP 2 Remove the fuel tank. Route the wiring harness from the FI Controller under the tank and through the frame.
PAGE 3
Installation Locate the 4 wire harness connector that goes to the stock injectors. Unplug this connector. STEP 4 STEP 4 Injector harness Plug the FI Controller connector into the stock injector harness. STEP 5 STEP 5 The Throttle Position Sensor (TPS) is located on the right side of the throttle body, behind the airbox. Unplug this connector.
PAGE 4
Installation On the TPS harness, locate the yellow wire. Using the supplied wire tap, tap into that wire. Make sure that the tap is on the wire securely. Connect the grey wire from the FI Controller harness to this connector. Reinstall the tank and seat.
PAGE 5
Controls Calibration The FI Controller is preprogrammed with 4 base fuel curves. The curves are selected using the switch labeled BASE. These curves adjust fuel delivery based on throttle position and RPM, providing the right amount of fuel under all conditions. The 4 fuel curves correspond to varying levels of performance modifications. The levels of modification are broken down into the following groups.