User Manual

4. Getting started

Dynaudio Acoustics BM14S 5

Controls and connections

1 AC IN

Mains power input.

2POWER ON (Main)

Main power switch (to switch the subwoofer manually on and off).

LED shows operation mode:

• red: subwoofer switched on and in mute mode

• green: subwoofer is activated

3 Power (Mode)

• On: subwoofer is permanently on

• Auto: subwoofer switches on when signal is detected

4Gain

Subwoofer volume level.

5 Lowpass

Subwoofer lowpass frequency: continuously variable from 50 to 150 Hz.

6 Phase

Phase setting: phase can be set to 0° or 180°.

7Mode

Subwoofer operation mode LFE or Slave:

• LFE: setting for normal use and Master use

• Slave: setting for second and all following subwoofers

8Highpass

Allows cutting off low frequencies of the signal provided at the

SAT/SUB

output:

• Flat: signal is not processed

• 60: cut-off frequency at 60 Hz

• 80: cut-off frequency at 80 Hz

9 SAT/SUB (output)

Output for satellite system to be connected. This signal is processed according to

the Highpass setting.

10 SAT/SUB (input)

Input for full bandwidth signal. This signal will be processed according to the

Highpass setting and provided at the SAT/SUB output.

11 LFE

• LFE/Slave: input for LFE signal

• Slave: output to next subwoofer if installed

Terminal pinout (sockets 9, 10 and 11)

1 = 0 2 = + 3 = –