Owner's Manual

Connecting the loudspeakers
1. Connect a two-pole (+/-) loudspeaker cable to the binding posts, located
at rear of the cabinet (see Fig. 1). The high quality, gold plated binding
posts can accommodate different connection systems:
–
4.0 mm banana plugs: The pins can be put directly into the binding
post without any tightening necessary.
–
Cable spades: Un-tighten the binding posts, insert the spade into the
opening, and secure the spade by tightening the posts (exc. Emit).
–
Bare wires: Un-tighten the binding posts and place the cable into the
binding posts. Tighten the posts.
Note
• With every connection system, ensure that the contact is tight and has a
proper contact area.
• Connectors with similar gold plating as binding posts will typically offer
the best results and remain corrosion-free.
• Please ensure that the positive and negative cables do not make contact
with each other. Tighten the posts, and check the contact after a few
days to make sure that it hasn’t loosened.
Connecting
06
Fig. 1 Binding posts at rear of cabinet (example)