Owner's Manual

2. Connect the other cable ends to the loudspeaker outputs of your
switched off power amp (see Fig. 2).
Note
Please make sure that the red marked post of the speaker is connected to the red
marked output of the amp, and the white or black marked post to the white or black
marked output accordingly.
Bi-wiring/bi-amping
Dynaudio loudspeakers feature a carefully fine-tuned cross-over, optimized using
selected parts and an advanced circuitry to achieve a truly balanced and smooth
frequency response. Therefore, dividing the frequency sections through bi-wiring or
bi-amping is neither beneficial nor optional.
Choice of loudspeaker cable
The loudspeaker cable can have an impact on sound quality. In general, quality cable
products will yield a quality result.
Dynaudio loudspeakers are designed to be very neutral and thus are not extremely
suited to any particular type of cable. The choice of cable is as much a factor of
matching the cable to the entire audio system. Please consult your Dynaudio dealer
for information about compatible loudspeaker cables that will suit both your electronics
and your Dynaudio loudspeakers.
Connecting surround speakers
When connecting a two-channel stereo system, only the right and left channels are
connected to the amplifier. In a surround set-up, center, side or rear loudspeakers as
well as a subwoofer are typically connected to provide for a multi-channel listening
experience. Please refer to the amplifier’s owner manual for particular connection inst-
ructions and see chapter “Multichannel loudspeaker setup” on page10 for further help.
Connecting
07
Fig. 2 Amplifier loudspeaker outputs (example)